Verint Nextiva S1700e Series Guia de Instalação descarregar pdf (Página 33)

Nextiva S1700e Series Installation Guide

Verint Video Solutions 23

* At least one of them must be transferred to obtain the LED condition.

The following power-up conditions on the system status LED are

abnormal:

 LED not lit—Check the power supply and cabling. If power is available

and the LED stays off, call Verint Video Solutions customer service for

assistance.

 Steady red LED persisting more than 10 seconds—There is an

internal error that prevents the device from starting normally. Power

down the device, wait 30 seconds, then power it up. If the condition

persists, call Verint Video Solutions customer service.

Flashing green (1 sec.

intervals)

The firmware has started, the device is connected to

the network, but no video/audio/serial* data is

transmitted.

Flashing green (0.2 sec.

intervals)

The firmware has started, the device is connected to

the network, and video/audio/serial* data is

transmitted.

Three consecutive red

blinks every 2 sec.

No video source is detected and no video is

transmitted.

Flashing green-red (1 sec.

intervals)

The device is undergoing a firmware update.

Flashing red (0.1 sec.

intervals)

The device is being identified.

Condition Indication

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 39

Sem comentários

Verint Nextiva S1700e Series Guia de Instalação Página 33